Center Pillar Upper Garnish Molding Replacement
Courtesy of GENERAL MOTORS COMPANY Center Pillar Upper Garnish Molding Replacement
| Callout |
Component Name |
|
Preliminary Procedures
- Disable the roof rail SIR system. Refer to SIR Disabling and Enabling
.
- Disconnect seat belt anchor from the seat. Refer to Seat Belt Retractor Pretensioner Replacement - Front
.
- Remove the seat belt opening close-out panel, located at the rear of the seat side shield panel, by pushing in and up to release the retaining tabs from the side shield.
|
| 1 |
Upper Garnish Molding Screw Cover |
| 2 |
Upper Garnish Molding Screw
Tighten
2 N.m (18 lb in) |
| 3 |
Center Pillar Upper Trim Panel Assembly Procedure
- Remove the seat belt D-ring from the adjuster assembly.
- Pull the trim panel toward the inside of the vehicle to disengage the retainers.
- Slide seat belt assembly through the opening in the molding.
|