LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of VSS & O-Ring
    GM10711Courtesy of GENERAL MOTORS CORP.
  1. Install the O-ring (11) to the VSS (10).
    2. Fig 2: Identifying Vehicle Speed Sensor (VSS)
    GM10516Courtesy of GENERAL MOTORS CORP.
  2. Install the VSS (10).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the VSS bolt (9).

    Tighten:  Tighten the bolt (9) to 12 N.m (106 lb in).

    4. Fig 3: View Of Vehicle Speed Sensor (VSS) Electrical Connector
    GM161100Courtesy of GENERAL MOTORS CORP.
  4. Connect the VSS electrical connector.
  5. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals