LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

  1. Position the transaxle bracket to the transaxle.
    2. Fig 1: View Of Transaxle Mount Bracket And Bolts
    GM161246Courtesy of GENERAL MOTORS CORP.
  2. Hand start the transaxle mount bracket to transaxle bolts.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the transaxle bracket bolts.

    Tighten:  Start with the forward lower bolt and work clockwise to tighten the transaxle bracket bolts to 95 N.m (70 lb ft).

  4. Remove the support from the transaxle.
    5. Fig 2: View Of Transaxle Bracket To Transaxle Mount Upper Nuts
    GM161248Courtesy of GENERAL MOTORS CORP.
  5. Install the transaxle bracket to the transaxle mount upper nuts.

    Tighten:  Tighten the nuts to 47 N.m (35 lb ft).

  6. Install the left engine splash shield.
  7. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals