LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
  1. Install the console shift control into the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the console shift control retaining nuts.

    Tighten:  Tighten the console shift control retaining nuts to 24 N.m (18 lb ft).

  3. Install the automatic transaxle range selector cable. Refer to Range Selector Lever Cable Replacement .
    4. Fig 2: Removing Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  4. Install the console shift control wiring harness.
  5. Install the console wiring harness.
  6. Install the console trim plate. Refer to FRONT FLOOR CONSOLE REPLACEMENT .
scientia non olet · About LEMON Manuals