Special Tools

• J 41103:  Torque Converter Seal Remover Set which contains:
• J 41103-1:  Torque Converter Seal Puller Legs
• J 41103-2:  Torque Converter Seal Puller Bridge
• J 41103-3:  Torque Converter Seal Support Body

For equivalent regional tools, refer to Special Tools .

Fig 1: Cross Sectional View Of J 41103 Components
Courtesy of GENERAL MOTORS CORP.
1. Insert the three J 41103-1:  puller legs under the Torque Converter Seal (525).
2. Insert the J 41103-3:  support body over the drive sprocket support (522).
3. Insert the J 41103-2:  puller bridge over the J 41103-3:  support body. Connect the J 41103-1:  puller legs into the slots on the J 41103-2:  puller bridge.
NOTE: The puller legs will damage the torque converter seal (525). Discard the torque converter seal (525) after removal.
4. Tighten the forcing screw on the J 41103-2:  puller bridge until the J 41103-1:  puller legs remove the torque converter seal (525).