LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Torque Converter Cover Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Torque Converter Covers
    GM631009Courtesy of GENERAL MOTORS CORP.
    NOTE: If equipped with 5.3L V8-The tab must be on the engine side of the engine oil pan bolt.
  1. Install the torque converter covers.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the torque converter cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals