LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Thermo Element Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Thermo Element Plate
    GM164816Courtesy of GENERAL MOTORS CORP.
  1. Use the J 34094-A  to set the middle thermo pin (123). See Special Tools .
  2. Install the new thermo element plate (122).
  3. Install the pin (120) and the washer.
  4. Use the J 34094-A  to set the height of the pin and the washer furthest from the accumulator. See Special Tools .
  5. Use the J 34094-A  to set the height of the second pin (120) and the washer. See Special Tools .
    6. Fig 2: View Of Thermo Element & Plate
    GM164817Courtesy of GENERAL MOTORS CORP.
  6. Install the thermo element (121) between the two pins (120). The V in the thermo element (121) must contact the thermo element plate (122).
  7. Install the oil pan. Refer to Oil Pan Replacement .
  8. Lower the vehicle.
    9. IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  9. Reset the TAP values. Refer to Transmission Adaptive Functions .
scientia non olet · About LEMON Manuals