LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .
  2. Disconnect the input speed sensor electrical connector.
    3. Fig 1: View Of Input Speed Sensor
    GM48196Courtesy of GENERAL MOTORS CORP.
  3. Remove the input speed sensor retaining clip (441).
  4. Remove the input speed sensor (440).
    5. Fig 2: Inspecting Input Speed Sensor
    GM49299Courtesy of GENERAL MOTORS CORP.
  5. Inspect the input speed sensor (440) for the following conditions:
    • Damaged or missing magnet
    • Damaged housing
    • Bent or missing electrical terminals
    • Damaged speed sensor clip (441)
scientia non olet · About LEMON Manuals