LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Forward Servo Replacement >> Removal Procedure

Removal Procedure

  1. Install the engine support fixture. Refer to Engine Support Fixture .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove and support the power steering gear. Refer to Steering Gear Replacement .
  4. Remove the transaxle mount lower nuts. Refer to Transmission Mount Replacement - Left Side .
  5. Remove the engine mount lower nuts. Refer to Engine Mount Replacement - Right Side .
  6. Remove the power steering lines from the right side of the frame.
  7. Support the rear of the frame with a jackstand.
  8. Loosen the front frame bolts and remove the rear frame bolts. Refer to FRAME REPLACEMENT .
  9. Adjust the jackstand to lower the rear of the frame.
  10. Position a drain pan under the forward servo cover.
    11. Fig 1: View Of Forward Servo Assembly
    GM164777Courtesy of GENERAL MOTORS CORP.
  11. Remove the servo cover bolts.
  12. Remove the forward servo cover.
  13. Remove the forward servo cover O-ring.
  14. Remove the servo piston assembly.
  15. Remove the servo spring.
scientia non olet · About LEMON Manuals