Driven Sprocket Support Bearing Assemble

Special Tools

J 34126: Driven Sprocket Bearing Installer and Remover
J 8092: Driver Handle

For equivalent regional tools, refer to Special Tools .

Fig 1: Using J 34126 & J 8092 To Install Driven Sprocket Support Bearing Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Position the driven sprocket support bearing assembly so that markings on the edge are facing up.

Use J 34126: bearing installer and remover (2), J 8092: driver handle (1) and a hammer in order to seat the driven sprocket support bearing assembly flush with or below the driven sprocket support assembly (609) hub.