Drive Sprocket Support Assemble

Special Tools

• J-8092:  Driver Handle
• J-28677:  Drive Sprocket Support Bearing Installer
• J-36850:  Transmission Assembly Lubricant

For equivalent regional tools, refer to Special Tools .

Fig 1: Pressing In Drive Sprocket Support Bearing With J 8092 & J 28677
Courtesy of GENERAL MOTORS CORP.
1. Assemble J-28677:  bearing installer and J-8092:  driver handle.
2. Lubricate drive sprocket support bearing (521) with J-36850:  lubricant.
NOTE: When installing the new bearing the part number should be visible (facing upward).
3. Using the assembled tool, press in the drive sprocket support bearing (521).
Fig 2: Locating Drive Sprocket Support Assembly
Courtesy of GENERAL MOTORS CORP.
4. Install the drive sprocket support assembly (522).
CAUTION: Refer to Fastener Caution .
5. Install the four drive sprocket support bolts (524) and tighten to 25 N.m (18 lb ft).