Special Tools

J 28585:  Snap Ring Remover

For equivalent regional tools, refer to Special Tools .

Fig 1: View Of Differential Carrier Internal Gear Snap Ring & Thrust Washer
Courtesy of GENERAL MOTORS CORP.
1. Remove the bearing (691) from the differential carrier internal gear.
2. Use J 28585:  snap ring remover or a large screwdriver in order to remove the differential carrier internal gear snap ring (692).
Fig 2: Removing Differential Carrier Internal Gear Assembly
Courtesy of GENERAL MOTORS CORP.
3. Lift the differential carrier internal gear assembly (693) out of the case by depressing the park pawl assembly in order to clear the case.