Case Cover Bearing Disassemble

Special Tools

• J 8092:  Universal Driver Handle
• J 41991:  Driveshaft Bearing Remover/Installer

For equivalent regional tools, refer to Special Tools .

Fig 1: Pressing Out Drive Shaft Bearing Assembly
Courtesy of GENERAL MOTORS CORP.
1. Assemble J 8092:  driver handle and J 41991:  bearing remover/installer for bearing removal.
2. Place the case cover (400) on a clean, flat surface with the spacer plate mating surface up.
3. Using the assembled tool, press the drive shaft bearing assembly (431) from the case cover (400).