Case Cover Bearing Assemble

Special Tools

• J 8092:  Universal Driver Handle
• J 41991:  Driveshaft Bearing Remover/Installer

For equivalent regional tools, refer to Special Tools .

Fig 1: Pressing Drive Shaft Bearing In With J 8092 & J 41991
Courtesy of GENERAL MOTORS CORP.
1. Assemble J 8092:  driver handle and J 41991:  bearing remover/installer for bearing installation.
2. Place the case cover (400) on a clean, flat surface with the case mating surface up.
NOTE: When installing the new bearing the part number should be visible (facing upward).
3. Using the assembled tool, press the drive shaft bearing (431) into the case cover (400).