LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Accumulator Assembly, 2-1 Band Servo Assemble

Accumulator Assembly, 2-1 Band Servo Assemble

    Fig 1: Identifying 2-1 Manual Band Servo Assembly
    GM13033Courtesy of GENERAL MOTORS CORP.
  1. Install the 2-1 manual band servo cover seal (105) into the case. Lubricate the 2-1 manual band servo cover seal (105) with automatic transmission fluid.
    2. CAUTION: Do not damage the 2-1 manual band servo exhaust screen on installation.
  2. Install the 2-1 manual band servo assembly (106-116) into the case. Make sure that the 2-1 manual band servo pin engages the 2-1 manual band assembly.
    3. Fig 2: View Of Accumulator & 2-1 Manual Band Servo Cover Assembly
    GM1956596Courtesy of GENERAL MOTORS CORP.
  3. Install the accumulator (132-140) and 2-1 manual band servo cover assembly (104) into the case.
  4. Install the lube oil pipe and washer assembly (130) through the case and into the lube hole in the differential carrier internal gear.
  5. Use a screwdriver in order to lock the lube oil pipe retainer (129) into the case.
    6. CAUTION: Refer to Fastener Caution .
  6. Install the three 2-1 manual band servo cover bolts (103) and tighten to 25 N.m (18 lb ft).
  7. Install the four accumulator cover bolts (131) and tighten to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals