Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Observe the DTCs with the scan tool.
- If DTC P0602 is set, attempt to program the ECM before replacing the ECM. Refer to Service Programming System (SPS) .
- If DTC P0602 resets, replace the ECM.
- Test the voltage and ground inputs to the ECM for the following:
- A short
- An open
- High resistance
IMPORTANT:
An intermittent or momentary, less than 1 second, loss of system voltage during throttle tip-in may set DTC P060D.
- If all circuits test normal, replace the ECM.