LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 5.3L - DTC P0016 To DTC P0358) >> DTC P0341 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: You must perform the Circuit/System Testing before proceeding with Component Testing.
  1. Inspect the CMP sensor for correct installation. Remove the CMP sensor from the engine and inspect the sensor O-ring for damage.
    • If the sensor is loose, incorrectly installed, or damaged, replace the CMP sensor.
  2. Connect the CMP sensor harness connector to the CMP sensor.
  3. Ignition ON, engine OFF, observe the CMP Active Counter parameter on the scan tool.
  4. Pass a flat steel object across the tip of the sensor repeatedly. The CMP Active Counter parameter should increment with each pass of the steel object.
    • If the parameter does not increment, replace the CMP sensor.
scientia non olet · About LEMON Manuals