Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P0131

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The loop status is Closed.
The ignition 1 signal is between 10-18 volts.
The fuel alcohol content is less than 87 percent.
The fuel level sensor is more than 10 percent.
The throttle position (TP) Indicated angle is between 3-70 percent.
DTC P0131 runs continuously when the above conditions are met for 2 seconds.

P0132

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The loop status is Closed.
The ignition 1 signal is between 10-18 volts.
The fuel alcohol content is less than 87 percent.
The fuel level sensor is more than 10 percent.
The throttle position (TP) sensor is between 0-70 percent.
DTC P0132 runs continuously when the above conditions are met for 2 seconds.

P0137

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The loop status is Closed.
The ignition 1 signal is between 10-18 volts.
The fuel alcohol content is less than 87 percent.
The fuel level sensor is more than 10 percent.
The TP sensor is between 3-70 percent.
DTC P0137 runs the lean test continuously when the above conditions are met for 2 seconds.

P0138

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The loop status is Closed.
The ignition 1 signal is between 10-18 volts.
The fuel alcohol content is less than 87 percent.
The fuel level sensor is more than 10 percent.
The TP sensor is between 3-70 percent.
DTC P0138 runs the rich test continuously when the above conditions are met for 2 seconds.