Conditions for Running the DTC

P0030 or P0036

• The ignition 1 signal is between 11-18 volts.
• The engine speed is more than 400 RPM.
• DTC P0030, P0036, P0053, P0054 runs continuously when the above conditions are met for 1 second.

P0053 or P0054

• DTCs P0112, P0113, P0117, P0118 are not set.
• The engine is started.
• The ignition voltage is less than 18 volts.
• The ignition is OFF for more than 10 hours.
• The engine coolant temperature (ECT) sensor is between -30 to +45°C (-22 to +113°F) at engine start-up.
• The ECT sensor minus the intake air temperature (IAT) sensor is less than 8°C (14°F) at engine start-up.
• DTCs P0053 and P0054 run once per drive cycle when the above conditions are met.

P0135

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0125, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
• The ECT sensor is more than 50°C (122°F).
• The ignition 1 signal is between 10-18 volts.
• The mass air flow (MAF) sensor is between 3-40 g/s.
• The engine run time is more than 300 seconds.
• The engine speed is between 500-3,000 RPM.
• DTC P0135 runs the heater current test once per drive cycle when the above conditions are met for 2 seconds.

P0141

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0125, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
• The ECT sensor is more than 50°C (122°F).
• The ignition 1 signal is between 10-18 volts.
• The MAF sensor is between 3-40 g/s.
• The engine run time is more than 300 seconds.
• The engine speed is between 500-3,000 RPM.
• DTC P0141 runs the heater current test twice per drive cycle when the above conditions are met for 120 seconds.