LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Valve Lifter Oil Manifold Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: All gasket surfaces should be free of oil or other foreign material during assembly.
    Fig 1: Valve Lifter Oil Manifold
    GM1536553Courtesy of GENERAL MOTORS CORP.
  1. Do not lift the manifold assembly by the electrical lead frame.
    2. Fig 2: View Of Outer Gasket
    GM1402014Courtesy of GENERAL MOTORS CORP.
  2. Install the outer gasket (556) onto the manifold.
    3. Fig 3: View Of Valve Lifter Oil Manifold
    GM1402004Courtesy of GENERAL MOTORS CORP.
  3. Install the valve lifter oil manifold (451).
    4. CAUTION: Refer to Fastener Caution .
  4. Install the valve lifter oil manifold bolts (506).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  5. Install the intake manifold. Refer to Intake Manifold Replacement .
scientia non olet · About LEMON Manuals