LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Oil Level Indicator and Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Indicator & Tube
    GM1411879Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil level indicator (418) from the tube.
  2. Remove the oil level indicator tube bolt (419).
  3. Remove the oil level indicator tube (420) from the engine block.
    4. NOTE: Inspect the O-ring for cuts or damage. The seal may be reused if it is not cut or damaged.
  4. Remove the O-ring seal from the tube, if necessary.
scientia non olet · About LEMON Manuals