LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Engine Mount Bracket Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount Bracket Nuts
    GM1551859Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the lower engine mount nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

    3. Fig 2: Exploded View Of Right Engine Mount
    GM1551853Courtesy of GENERAL MOTORS CORP.
  3. Using the engine support fixture, lower the engine.
  4. Remove the engine support fixture.
  5. Install the upper engine mount nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  6. Install the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (3.8L) or Exhaust Manifold Replacement - Right Side (LS4) .
  7. Install the engine mount strut. Refer to Engine Mount Strut Replacement .
scientia non olet · About LEMON Manuals