LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement - Accessory >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Tensioner Bolts
    GM1616421Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt tensioner.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the drive belt tensioner bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: Locating Power Steering Gear Inlet Hose Retainer Bolt
    GM1655133Courtesy of GENERAL MOTORS CORP.
  3. Install the power steering gear inlet hose retainer bolt (2).

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  4. Install the right engine splash shield.
  5. Install the right wheel and tire. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
  7. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals