LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Drive Belt Replacement - Accessory >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Using EN-47988 To Belt Tensioner And Ensuring That EN-47988 Is NOT Installed Above Drive Belt
    GM1759725Courtesy of GENERAL MOTORS CORP.
  1. Install and route the drive belt around all the pulleys except for the power steering pump pulley.
  2. Ensure that when installing the EN-47988  (1), to the belt tensioner that the EN-47988  is NOT installed above the drive belt (2). See Special Tools .
    3. Fig 2: Ensure That When Installing EN-47988 To The Belt Tensioner That EN-47988 Is Installed Below Drive Belt
    GM1759722Courtesy of GENERAL MOTORS CORP.
  3. Ensure that when installing the EN-47988  (1), to the belt tensioner that the EN-47988  is installed below the drive belt (2). See Special Tools .
  4. Rotate the EN-47988  clockwise in order to relieve the tension on the belt tensioner. See Special Tools .
  5. Ensure that the drive belt is still properly routed around all the other pulleys, then install the drive belt over the power steering pump pulley.
  6. Slowly release the EN-47988  . See Special Tools .
  7. Remove the EN-47988  from the belt tensioner. See Special Tools .
  8. Inspect the drive belt for proper installation and alignment.
  9. Position the UBEC, if required.
  10. Install the passenger side diagonal brace, if required. Refer to FRONT FENDER UPPER DIAGONAL BRACE REPLACEMENT .
scientia non olet · About LEMON Manuals