Valve Rocker Arm Cover Installation - Left Side

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Valve Rocker Arm Cover Gasket

Courtesy of GENERAL MOTORS CORP.

NOTE:

All gasket surfaces should be free of oil or other foreign material during assembly.
DO NOT use the valve rocker arm cover gasket again.
The valve rocker arm cover bolt grommets may be used again if not damaged.

Fig 2: Oil Fill Cap & Oil Fill Tube

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Valve Rocker Arm Cover Bolts And Cover

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the cover bolts with grommets and tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

Fig 4: View Of Bracket, Bolts, Coils & Wire Harness

Courtesy of GENERAL MOTORS CORP.

Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bolts (723).
Install the ignition coils (722), wire harness (721), and bolts (723) to the bracket (719) and tighten the ignition coil bolts to 8 N.m (71 lb in).

Fig 5: View Of The Ignition Coil And Bracket Assembly

Courtesy of GENERAL MOTORS CORP.

Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bracket studs (720).
Install the ignition coil and bracket assembly (719) and studs (720) and tighten the bracket studs to 12 N.m (106 lb in).