LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - Off Vehicle >> Piston, Connecting Rod, and Bearing Cleaning and Inspection >> Measuring Piston Ring End Gap

Measuring Piston Ring End Gap

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Measuring Piston Ring End Gap
    GM4968Courtesy of GENERAL MOTORS CORP.
    NOTE:
    • Do not attempt to file the end of the piston ring to achieve the proper end gap clearance.
    • Measure the piston ring in the cylinder in which it will be used.
  1. Place the piston ring into the cylinder bore 6.5 mm (0.25 in) below the top of the ring travel area.
  2. Insert a feeler gage and measure the piston ring end gap. Refer to Engine Mechanical Specifications .
scientia non olet · About LEMON Manuals