LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - Off Vehicle >> Oil Pump Assemble

Oil Pump Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exploded View Of Oil Pump
    GM1402152Courtesy of GENERAL MOTORS CORP.
    NOTE: Prior to assembling the oil pump, coat all wear or internal surfaces with clean engine oil.
  1. Install the driven gear (412) into the pump housing (413).

    Install the driven gear with the orientation mark facing the pump cover.

  2. Install the drive gear (410) into the pump housing.
  3. Install the oil pump cover (409).
    4. CAUTION: Refer to Fastener Caution .
  4. Install the pump cover bolts (408) and tighten to 12 N.m (106 lb in).
  5. Install the relief valve (414).
  6. Install a NEW relief valve spring (415).
  7. Install the pressure relief valve plug (416) and tighten to 12 N.m (106 lb in).
  8. Inspect the oil pump for smooth operation by rotating the drive gear.
scientia non olet · About LEMON Manuals