Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

Inspect the following components:
- Cylinder walls for excessive scratches, gouging, or ring ridge
- Cylinder bores for excessive ring ridge at the top of the cylinder
- Coolant jacket for cracks
- Valve lifter bores for excessive scoring or wear
- Crankshaft bearing webs for cracks
- Gasket sealing surfaces for excessive scratches or gouging
  Refer to Replacing Engine Gaskets .
- Oil galleries for restrictions
- Threaded bolt holes for damaged threads
- Scoring or damage to the displacement on demand oil passages or sealing surfaces
Measure the cylinder bores for excessive ring ridge at the top of the cylinder.