LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - Off Vehicle >> Crankshaft Balancer Removal >> Removal

Crankshaft Balancer Removal: Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Flywheel Holding Tool
    GM1602753Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.
  1. Install the EN 47699:  tool (2), spacer (1), and bolt (3) to the block and flex plate.
    2. Fig 2: Identifying Flywheel Holding Tool
    GM1602754Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Tighten the EN 47699:  tool bolt (1) to 60 N.m (44 lb ft).
    3. Fig 3: View Of Crankshaft Balancer Bolt
    GM1411870Courtesy of GENERAL MOTORS CORP.
  3. Remove the crankshaft balancer bolt (139).

    Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.

    4. Fig 4: Installing Special Tools To Crankshaft Balancer
    GM1411872Courtesy of GENERAL MOTORS CORP.
  4. Use the J 41816:  remover (1) and the J 41816-2:  protector (2) in order to remove the crankshaft balancer.
    5. Fig 5: Removing/Installing Crankshaft Balancer
    GM1411874Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft balancer (138).
  6. Remove the EN 47699:  tool, bolt, and spacer.
scientia non olet · About LEMON Manuals