LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 5.3L) >> Repair Instructions - Off Vehicle >> Crankshaft Balancer Installation >> Installation

Crankshaft Balancer Installation: Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Flywheel Holding Tool
    GM1602753Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE:
    • The crankshaft balancer is balanced as an individual component. It is not necessary to mark the balancer prior to removal.
    • The crankshaft balancer installation and bolt tightening involves a 4 stage tightening process. The first pass ensures that the balancer is installed completely onto the crankshaft. The second, third and fourth passes tighten the NEW bolt to the proper torque.
    • The used crankshaft balancer bolt is used only during the first pass of the balancer installation procedure. Install a NEW crankshaft balancer bolt and tighten as described in the second, third and fourth passes of the balancer bolt tightening procedure.
    • Ensure the teeth of the tool engage the engine flywheel teeth.
  1. Install the EN 47699:  tool (2), spacer (1), and bolt (3) to the block and flywheel.
    2. Fig 2: Identifying Flywheel Holding Tool
    GM1602754Courtesy of GENERAL MOTORS CORP.
  2. Tighten the EN 47699:  tool bolt (1) to 60 N.m (44 lb ft).
    3. Fig 3: Removing/Installing Crankshaft Balancer
    GM1411874Courtesy of GENERAL MOTORS CORP.
    NOTE: The balancer should be positioned onto the end of the crankshaft as straight as possible prior to tool installation.
  3. Position the balancer (138) onto the end of the crankshaft.
    4. Fig 4: Using Special Tools To Install Crankshaft Balancer
    GM1411964Courtesy of GENERAL MOTORS CORP.
  4. Use the J 41478:  installer and the J 41665:  installer in order to install the balancer.
    1. Assemble the J 41478:  installer threaded rod, nut, washer and J 41665:  installer installer.

      Insert the smaller end of the installer into the front of the balancer.

    2. Use a wrench and hold the hex end of the threaded rod.
    3. Use a second wrench and rotate the installation tool nut clockwise until the balancer is started onto the crankshaft.
    4. Remove the tool and reverse the installation tool.

      Position the larger end of the installer against the front of the balancer.

    5. Use a wrench and hold the hex end of the threaded rod.
    6. Use a second wrench and rotate the installation tool nut clockwise until the balancer is installed onto the crankshaft.
    7. Remove the balancer installation tools.
    5. Fig 5: View Of Crankshaft Balancer Bolt
    GM1411870Courtesy of GENERAL MOTORS CORP.
  5. Install the NEW crankshaft balancer bolt (139).
    1. Tighten the crankshaft balancer bolt a first pass to 150 N.m (110 lb ft) .
    2. Loosen the crankshaft balancer bolt a second pass 360 degrees .
    3. Tighten the crankshaft balancer bolt a third pass to 50 N.m (37 lb ft) .
    4. Tighten the crankshaft balancer bolt a final pass 230 degrees using the J 45059:  meter .
  6. Remove the EN 47699:  tool spacer and bolt.
scientia non olet · About LEMON Manuals