Anaerobic Sealer
WARNING: This page is about a different variant/trim than selected.
- Anaerobic gasket eliminator hardens in the absence of air. This type of sealer is used where 2 rigid parts, such as castings, are assembled together. When 2 rigid parts are disassembled and no sealer or gasket is readily noticeable, the parts were probably assembled using a gasket eliminator.
- Follow all safety recommendations and directions that are on the container.
To remove the sealant or the gasket material, refer to Replacing Engine Gaskets .
- Apply a continuous bead of gasket eliminator to 1 flange. Surfaces to be sealed must be clean and dry.
- Spread the sealer evenly with your finger to get a uniform coating on the sealing surface.
- Tighten bolts to specifications. Do not overtighten.
- After properly tightening the fasteners, remove the excess sealer from the outside of the joint.
CAUTION:
Refer to Sealant Caution
.
NOTE:
Anaerobic sealed joints that are partially torqued and allowed to cure more than 5 minutes may result in incorrect shimming and sealing of the joint.