LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays & Gauges >> Diagnostic Information and Procedures >> DTC P0520 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the engine oil pressure (EOP) switch.
  2. Ignition OFF, test for less than 5 ohms between the ground circuit terminal B and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance. If the circuit tests normal, replace the PCM.
  3. Ignition ON, verify the scan tool Engine Oil Pressure Switch parameter is OK.
    • If not the specified value, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the PCM.
  4. Ignition ON, install a 3A fused jumper wire between the signal circuit terminal A and the ground circuit terminal B. Verify the scan tool Engine Oil Pressure Switch parameter is Low.
    • If not the specified value, test the signal circuit for an open/high resistance. If circuit test normal, replace the PCM.
  5. If all circuits test normal, test or replace the engine oil pressure switch.
scientia non olet · About LEMON Manuals