Torque Sequence

Fig 1: Identifying Front Differential Carrier Assembly Torque Sequence

Courtesy of GENERAL MOTORS CORP.

Torque Sequence

Callout	Component Name
1	Spacer Bolt M8 x 127 (Qty: 8) NOTE: Refer to Fastener Notice . Tip: Install the remaining spacers evenly at every other bolt hole. Remove the DT 47800-6 which is part of DT-47800 , guide pins and install spacer bolts in all bolt holes at spacer locations. See Special Tools . Tighten: Tighten the bolts in sequence to 30 N.m (22 lb ft) Special Tool: DT-47800 Thrust Washer Selection Gage Kit. See Special Tools .
2	Front Differential Carrier Assembly NOTE: If the bearings are not properly seated into the bearing cups, the washer selection will be inaccurate and the bearing pre-load will be set too low. Low bearing pre-load will cause premature failure of the front differential drive pinion gear. Rotate the differential assembly 10 revolutions to allow the bearings to seat into the cups. Tip: Differential rotating tool DT-47793 can be used to rotate the differential from the case side. See Special Tools . Special Tool: DT-47793 Differential Rotating Tool. See Special Tools .

Callout

Component Name

Spacer Bolt M8 x 127 (Qty: 8)

NOTE: Refer to Fastener Notice .

Tip:

Install the remaining spacers evenly at every other bolt hole.
Remove the DT 47800-6 which is part of DT-47800 , guide pins and install spacer bolts in all bolt holes at spacer locations. See Special Tools .
Tighten: Tighten the bolts in sequence to 30 N.m (22 lb ft)

Special Tool:
DT-47800 Thrust Washer Selection Gage Kit. See Special Tools .

Front Differential Carrier Assembly

NOTE: If the bearings are not properly seated into the bearing cups, the washer selection will be inaccurate and the bearing pre-load will be set too low. Low bearing pre-load will cause premature failure of the front differential drive pinion gear.

Rotate the differential assembly 10 revolutions to allow the bearings to seat into the cups.
Tip: Differential rotating tool DT-47793 can be used to rotate the differential from the case side. See Special Tools .
Special Tool:
DT-47793 Differential Rotating Tool. See Special Tools .