LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Brace Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Transaxle Brace & Bolts
    GM160962Courtesy of GENERAL MOTORS CORP.
  1. Install the transaxle brace.
  2. Hand start the bolts to the engine and to the transaxle.
    3. NOTE: Refer to Fastener Notice .
  3. Install the transaxle brace bolts to the transaxle.

    Tighten:  Tighten the transaxle brace bolts to the transaxle to 43 N.m (32 lb ft).

  4. Install the transaxle brace bolts to the engine.

    Tighten:  Tighten the transaxle brace bolts to the engine to 63 N.m (46 lb ft).

  5. Install the oil filter adapter. Refer to Oil Filter Adapter and Bypass Valve Assembly Replacement .
  6. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals