LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Output Shaft Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Drive Axle Retainer Rings & Output Shaft
    GM214419Courtesy of GENERAL MOTORS CORP.
  1. Install the drive axle retainer rings (509) to the output shaft (510).
  2. Hold the front differential carrier in place and carefully install the output shaft (510) to the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
  3. Install the case extension housing. Refer to Case Extension Replacement .
  4. Install the left drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
scientia non olet · About LEMON Manuals