LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Oil Seal Replacement - Left Side >> Installation Procedure

Installation Procedure

  1. Lubricate the seal lip with transaxle fluid.
    2. IMPORTANT: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface.
  2. Install J 37292-B  in the seal (409). See Special Tools .
    3. Fig 1: Identifying Left Oil Seal
    GM190634Courtesy of GENERAL MOTORS CORP.
  3. Use J 34115  to install the new seal. See Special Tools .
  4. Remove the J 37292-B  . See Special Tools .
  5. Install the drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
  6. Install the left lower ball joint to the left steering knuckle. Refer to Steering Knuckle Replacement .
  7. Install the left tie rod end to the left steering knuckle. Refer to Steering Knuckle Replacement .
  8. Install the left stabilizer shaft link to the left lower control arm. Refer to Stabilizer Shaft Link Replacement .
  9. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
    11. NOTE: Refer to TRANSMISSION OVERFILL NOTICE .
  11. Adjust the fluid level.
  12. Inspect for proper completion of the repairs.
  13. Inspect for proper fluid level.
  14. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals