LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Fluid Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .
    2. Fig 1: Locating Wiring Harness & Electrical Connectors
    GM48209Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the wiring harness assembly from the fluid temperature sensor (391).
  3. Remove the fluid temperature sensor (391).
scientia non olet · About LEMON Manuals