LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Case Extension Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LY7) or Battery Negative Cable Disconnection and Connection (LS4) .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the right drive axle from the transaxle. Refer to Wheel Drive Shaft Replacement .
  4. Remove the transaxle brace. Refer to Transmission Brace Replacement .
  5. Remove the vehicle speed sensor. Refer to Vehicle Speed Sensor Replacement .
    6. Fig 1: View Of Case Extension Assembly & Bolts
    GM10517Courtesy of GENERAL MOTORS CORP.
  6. Remove the case extension housing bolts (5).
  7. Remove the case extension housing (6) with the axle seal and the O-ring (8).
scientia non olet · About LEMON Manuals