LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Driven Sprocket Support Components Disassemble >> Disassembly Procedure

Disassembly Procedure

    Fig 1: View Of J 4670-01, Fourth Clutch Spring Assembly & Snap Ring
    GM10670Courtesy of GENERAL MOTORS CORP.
  1. Use J 4670-01  clutch spring compressor in order to compress the fourth clutch spring assembly (602). See Special Tools . Remove the snap ring (601) from the driven sprocket support assembly.
    2. Fig 2: View Of Spring Assembly & Fourth Clutch Piston Assembly
    GM10671Courtesy of GENERAL MOTORS CORP.
  2. Remove the spring assembly (602) and remove the fourth clutch piston assembly (603) from the driven sprocket support assembly (609).
    3. Fig 3: Locating Fourth Clutch Piston Outer Seal
    GM10672Courtesy of GENERAL MOTORS CORP.
  3. Remove the outer seal (604) from the fourth clutch piston (603).
    4. Fig 4: View Of Inner Seal & Oil Seal Rings At Driven Sprocket Support
    GM788713Courtesy of GENERAL MOTORS CORP.
  4. Remove the inner seal (605) for the fourth clutch piston from the driven sprocket support assembly hub.
  5. Remove the oil seal rings (613) from the driven sprocket support.
scientia non olet · About LEMON Manuals