LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Driven Sprocket Support Assembly Removal

Driven Sprocket Support Assembly Removal

    Fig 1: Identifying Driven Sprocket Support Assembly
    GM870974Courtesy of GENERAL MOTORS CORP.
  1. With your fingers, insert two 13 mm channel plate bolts (434) into the driven sprocket support assembly (609).
  2. Grasp the bolts and lift the support assembly from the case.
  3. Remove the thrust washer (611) from the second clutch housing. The washer may be stuck to the support assembly.
scientia non olet · About LEMON Manuals