Case Cover Bearing Disassemble

Tools Required

• J 8092  Driver Handle. See Special Tools .
• J 41991  Driveshaft Bearing Remover/Installer. See Special Tools .

Fig 1: Identifying Drive Shaft Bearing Assembly
Courtesy of GENERAL MOTORS CORP.
1. Assemble J 8092  and J 41991  for bearing removal. See Special Tools .
2. Place the case cover (400) on a clean, flat surface with the spacer plate mating surface up.
3. Using the assembled tool, press the drive shaft bearing assembly (431) from the case cover (400).