Conditions for Running the DTCs

P0638 and P2101

• The ignition is ON or the engine is operating.
• The ignition voltage is greater than 7 volts.
• Throttle position adaptation is not active.
• DTCs P0638 and P2101 run continuously once the above conditions are met for greater than 1 second.

P2100

• Before the ECM can report DTC P2100 failed, DTC P0638 must run and pass.
• The ignition is ON or the engine is operating.
• DTC P2100 runs continuously once the above conditions are met for greater than 1 second.

P2119

• The ignition is ON.
• The vehicle speed is 0 km/h (0 mph).
• The engine speed is less than 40 RPM.
• The engine coolant temperature (ECT) is 5-100°C (41-212°F).
• The intake air temperature (IAT) is 5-143°C (41-290°F).
• The ignition voltage is greater than 10 volts.
• The accelerator pedal position (APP) is less than 15 percent.
• DTC P2119 runs once per ignition cycle when the above conditions are met for less than 1 second.