Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, observe the scan tool DTC information. Verify DTCs P0121, P0122, P0123, P0221, P0222, or P0223 are not set.
- If any of the DTCs are set refer to DTC P0121, P0122, P0123, P0221, P0222, or P0223 for further diagnosis.
- Verify the scan tool TP sensor 1 voltage parameter is between 3.24-3.54 volts, and TP sensor 2 voltage parameter is between 1.36-1.86 volts.
- If either TP sensor voltage is not within the specified range refer to DTC P0121, P0122, P0123, P0221, P0222, or P0223 for further diagnosis.
- Rapidly depress the accelerator pedal from the rest position to the wide open throttle position (WOT) and release the pedal. Repeat the procedure several times. DTCs P0638, P2111, P2112, or P2119 should not set.
- If any of the DTCs P0121, P0122, P0123, P0221, P0222, or P0223 set while performing this procedure refer to DTC P0121, P0122, P0123, P0221, P0222, or P0223 for further diagnosis.
- Slowly depress the accelerator pedal to WOT and then slowly return the pedal to closed throttle. Repeat the procedure several times. DTCs P0638, P2111, P2112, or P2119 should not set.
- If any of the DTCs P0121, P0122, P0123, P0221, P0222, or P0223 set while performing this procedure refer to DTC P0121, P0122, P0123, P0221, P0222, or P0223 for further diagnosis.
- Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records Data List.