Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
The following conditions must be met prior to the ignition OFF test.
- DTCs P0101, P0102, P0103, P0112, P0113, P0117, P0118, P0125, P0128, P0443, P0446, P0449, P0451, P0452, P0453, P0458, P0459, P0496, P0498, P0499, P0560, P0562, P0563, P0700, P2228, and P2229 are not set.
- The ignition 1 voltage is greater than 11 volts.
- A refueling event is not detected
- The fuel volatility is not excessive.
- The ambient air temperature (AAT) is between 2-32°C (35-90°F).
- The start-up intake air temperature (IAT) is between 2-32°C (36-90°F).
- The start-up engine coolant temperature (ECT) is less than 40°C (104°F) and within 10°C (18°F) of the IAT.
- The ECT is greater than 74°C (165°F) at engine OFF.
- The barometric pressure (BARO) is greater than 68 kPa.
- The fuel level is between 12-88 percent.
- The vehicle traveled greater than 8 km (5 mi) with vehicle speed above 2.5 km/h (1.6 mph).
- The engine run time is greater than 10 minutes.
- DTC P0442 runs once per engine off cycle when the above conditions have been met prior to engine shut down.