Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the harness connector at the CKP sensor.
- Test for 700-1,200 ohms of resistance between the signal circuit and low reference circuit of the CKP sensor.
- If not within the specified range, replace the CKP sensor.
- Disconnect the fuel pump relay.
- Set the DMM to the AC voltage scale.
- While cranking the engine, test for greater than 1.3 VAC between the signal circuit and low reference circuit of the CKP sensor.
- If less than the specified range, replace the CKP sensor.