Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0121, P0122, P0123, P0221, P0222, P0223, P0335, P0336, P0338, P0461, P0462, P0463, and P0464 are not set.
The engine speed is between 400-7,000 RPM and steady.
The delivered torque signal is greater than 10 percent at idle.
The delivered torque signal is between 12-43 percent with the transmission in drive.
The intake air temperature (IAT) is greater than -30°C (-22°F).
The fuel level is greater than 10 percent.
The torque management is not active.
The antilock brake system (ABS)/traction control system (TCS) is not active.
The ECM is not receiving a rough road signal.
The fuel cut-off is not active, including the traction control, the deceleration, the high vehicle speed, and the high engine speed.
DTCs P0300 through P0306 run continuously when the above conditions exist for at least 1000 engine revolutions.