Conditions for Running the DTCs

WARNING: This page is about a different variant/trim than selected.

Before the ECM can report DTC P0141 failed, DTCs P0036, P0037, and P0038 must run and pass.
DTCs P0137, P0138, P0140, P2232, P2270, and P2271 are not set.
The engine is operating.
The ignition 1 voltage is between 11-18 volts.
The ECM internal sensing element resistance test is enabled.
The fuel system is not in a decel fuel shut-off.
The intake air temperature (IAT) is greater than -10°C (14°F).
If the engine is operating and then the ignition is turned OFF, the engine must be OFF for at least 2 minutes before the next start-up for the diagnostic to run.
The calculated exhaust temperature is between 360-500°C (680-932°F).
DTC P0141 runs continuously once the above conditions are met for greater than 100 seconds.