Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

Before the ECM can report DTC P0101 failed, DTCs P0102, P0103, P0111, P0112, P0113, P0121, P0122, P0123, P0221, P0222, P0223, P0335, P0336, and P0338 must run and pass.
DTC P2176 is not set.
The engine is operating for greater than 1 second.
The MAF sensor signal is greater than 11 grams per second.
The ignition voltage is greater than 11 volts.
The ECM detects greater than 150 revolutions of the crankshaft.
DTC P0101 runs continuously once the above conditions are met.