Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, observe the scan tool DTC information. Verify DTCs P0102, or P0103 are not set.
- If DTCs P0102, or P0103 are set refer to DTC P0102 or P0103 for further diagnosis.
- Engine idling for 1 minute, observe the scan tool DTC information. DTC P0101 should not set.
- Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records Data List.