LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 5.3L - Troubleshooting & Diagnosis) >> Powertrain Relay Diagnosis >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components that have been removed or replaced during diagnosis.
  2. Perform any adjustment, programming, or setup procedures that are required when a component or module is removed or replaced.
  3. Clear the DTCs.
  4. Turn OFF the ignition for 60 seconds.
  5. Ignition ON, command the powertrain relay ON and OFF with a scan tool, while observing the powertrain relay circuit status parameters, The circuit status parameters should change from OK to Not Run or Not Run to OK.
scientia non olet · About LEMON Manuals